TCP Server

General

Allows third party Ethernet clients to remotely control DDUtil_V3 functionality.

Setup

Connection

Connections are restricted the Local Area Network (LAN) that DDUtil is connected to.

• Use the IP address of the host PC DDUtil is open on; i.e. 192.168.1.xxx.
• Use port 5678

Commands

GETSLICE  -  Gets frequency of slice n (n = 0-7)						  
   Form:     GETSLICE P1 \r\n			
   Parm:     P1 = Slice number 0-7
   Uses:     GETSLICE2\r\n	
   Rtrn:     Slice2:00014123456

SETSLICE  -  Sets frequency of slice n (n = 0-7)						  
   Form:     SETSLICE P1 \r\n			
   Parm:     P1 = Slice number 0-7
   Uses:     SETSLICE2\r\n	
   Rtrn:     ACK

GETROTOR  -  Gets Rotor position						  
   Form:     GETROTOR \r\n			
   Uses:     GETROTOR\r\n	
   Rtrn:     Head:045

SETROTOR  -  Sets Rotor position						  
   Form:     SETROTOR \r\n			
   Uses:     SETROTOR045\r\n	
   Rtrn:     Head:045 (when finished turning)

TOGGLEPTT -  Toggle Auto Drive Oper/Stby (PTT)						
    Form:    TOGGLEPTT \r\n			
    Uses:    TOGGLEPTT\r\n	
    Rtrn:    PTT:{Oper|Stby}

   A95PWR -  A9500 Amp Power On						
    Form:    A95PWR \r\n			
    Uses:    A95PWR\r\n	
    Rtrn:    ACK

   A95AUX -  A9500 Aux Power On / PowerOff						
    Form:    A95AUX \r\n			
    Uses:    A95AUX\r\n	
    Rtrn:    ACK

  A95AUTO -  A9500 Auto Mode On/Off (toggle)						
    Form:    A95AUTO \r\n			
    Uses:    A95AUTO\r\n	
    Rtrn:    ACK

   A95ANT -  A9500 Antenna Select (steps 1-4)						
    Form:    A95ANT \r\n			
    Uses:    A95ANT\r\n	
    Rtrn:    ACK

  A95MODE -  A9500 Oper/Stby (toggle)						
    Form:    A95MODE \r\n			
    Uses:    A95MODE\r\n	
    Rtrn:    ACK