Difference between revisions of "SPE 1.3/2K"
From DDUtilV3
(Created page with "==General== DDUtil can remotely control the '''SPE 1.3/2k''' amplifier using RS232 serial ports attached to your PC. The following actions can be controlled from '''DDUtil'''....") |
|||
| Line 1: | Line 1: | ||
==General== | ==General== | ||
| − | DDUtil can remotely control the '''SPE 1.3/2k''' amplifier using RS232 serial ports attached to your PC. The following actions can be controlled from '''DDUtil'''. | + | DDUtil can remotely control the '''SPE 1.3/2k''' amplifier using RS232 serial ports attached to your PC. The following actions can be controlled from '''DDUtil'''. '''Note:''' the following descriptions are for the 2K model. Some features on the 1.3K are different so consult the owners manual for differences. |
*Power On/Off | *Power On/Off | ||
*Operate/Stby (toggle) | *Operate/Stby (toggle) | ||
| Line 8: | Line 8: | ||
*Input (toggle: 1-2) | *Input (toggle: 1-2) | ||
*Tune (initiate) | *Tune (initiate) | ||
| + | *Display (reset amp alarm) | ||
*Alarms and Warnings display | *Alarms and Warnings display | ||
| Line 15: | Line 16: | ||
Two serial connections are required for the '''SPE 1.3/2K''' to communicate with '''DDUtil'''. One for the remote commands and one for band switching. | Two serial connections are required for the '''SPE 1.3/2K''' to communicate with '''DDUtil'''. One for the remote commands and one for band switching. | ||
===Remote Commands=== | ===Remote Commands=== | ||
| + | Use either the USB cable furnished with the amplifier or the '''Port''' connector on the back of the amp. If the '''Port''' connector is used a special cable is required. | ||
| + | [[Image:SpePortWiring.jpg]] | ||
===Band Switching=== | ===Band Switching=== | ||
==DDUtil Setup== | ==DDUtil Setup== | ||
Revision as of 05:37, 23 October 2015
General
DDUtil can remotely control the SPE 1.3/2k amplifier using RS232 serial ports attached to your PC. The following actions can be controlled from DDUtil. Note: the following descriptions are for the 2K model. Some features on the 1.3K are different so consult the owners manual for differences.
- Power On/Off
- Operate/Stby (toggle)
- PA Temp display
- Antenna selection (toggle: 1-6)
- Output Power (toggle: Low/Med/High)
- Input (toggle: 1-2)
- Tune (initiate)
- Display (reset amp alarm)
- Alarms and Warnings display
To connect and use the SPE 2K amplifier follow the steps below.
Connection Data
Two serial connections are required for the SPE 1.3/2K to communicate with DDUtil. One for the remote commands and one for band switching.
Remote Commands
Use either the USB cable furnished with the amplifier or the Port connector on the back of the amp. If the Port connector is used a special cable is required.
