Difference between revisions of "SPE 1.3/2K"

From DDUtilV3
Jump to: navigation, search
(Created page with "==General== DDUtil can remotely control the '''SPE 1.3/2k''' amplifier using RS232 serial ports attached to your PC. The following actions can be controlled from '''DDUtil'''....")
(No difference)

Revision as of 10:12, 30 September 2015

General

DDUtil can remotely control the SPE 1.3/2k amplifier using RS232 serial ports attached to your PC. The following actions can be controlled from DDUtil.

  • Power On/Off
  • Operate/Stby (toggle)
  • PA Temp display
  • Antenna selection (toggle: 1-6)
  • Output Power (toggle: Low/Med/High)
  • Input (toggle: 1-2)
  • Tune (initiate)
  • Alarms and Warnings display

To connect and use the SPE 2K amplifier follow the steps below.

Connection Data

Two serial connections are required for the SPE 1.3/2K to communicate with DDUtil. One for the remote commands and one for band switching.

Remote Commands

Band Switching

DDUtil Setup