Difference between revisions of "CW Skimmer"

From DDUtilV3
Jump to: navigation, search
(Created page with "==CW Skimmer== ===General=== This implementation loads and connects '''SmartSDR''' to '''CW Skimmer''' without using a virtual serial port pair. Connection is accomplished usi...")
(No difference)

Revision as of 17:51, 15 May 2014

CW Skimmer

General

This implementation loads and connects SmartSDR to CW Skimmer without using a virtual serial port pair. Connection is accomplished using TCP/IP and special Telnet commands.

Setup

  • You must own a registered copy of CW Skimmer which can be obtained from the DX Atlas web site.
    • Make sure you have the latest version of CW Skimmer (1.83 or later).
  • In DDUtil select the Enable check box in the CW Skimmer group on the Features tab.
  • When CW Skimmer starts open the Settings pane and configure the following tabs and settings.
    • Radio tab
      • Hardware TypeSoftRock
      • Sample Rate → to match DAX IQ Stream in the DAX control panel for slice A.
      • Lo Frequency → This is automatically set by DDUtil.
      • CW Pitch → to match the CW Pitch frequency in the SmartSDR CW panel.
    • Audio tab
      • Soundcard DriverWDM.
      • Signal I/O DeviceDAX IQ RX 1.
      • Audio I/O Device → to match your system's Play Back Audio Device.
      • All other settings use the default values.
    • Operator tab
      • Set as required.
    • Telnet tab
      • Enable Telnet Server → selected.
      • Port7310
      • Require Password → not selected.
      • Do not send callsigns without CQ → user preference, but usually not selected.
      • Allow Skimmer Commands → selected
  • Open the DAX Control panel
    • In the IQ Streams group
      • Set the #1 sample rate to match what you setup in the CW Skimmer settings panel.
      • Enable the #1 stream by pressing the #1 button.

Operation

  • Use CW Skimmer as you would normally with the following advice.
    • Frequency control is best set from CW Skimmer.
    • Frequency set from SSDR will not always be exact as CW Skimmer has a - 100KHz step. If you set the SSDR frequency to 14.010.123 CW Skimmer will change it to 14.010.100. So depending on where the station is it might be hard to get CW Skimmer close enough to decode properly. Using CW Skimmer to tune the station has more granularity and works better. The next version of CW Skimmer is supposed to accept 10 Hz tuning steps