Difference between revisions of "SPE 1.3/2K"
From DDUtilV3
(Created page with "==General== DDUtil can remotely control the '''SPE 1.3/2k''' amplifier using RS232 serial ports attached to your PC. The following actions can be controlled from '''DDUtil'''....") |
(No difference)
|
Revision as of 10:12, 30 September 2015
General
DDUtil can remotely control the SPE 1.3/2k amplifier using RS232 serial ports attached to your PC. The following actions can be controlled from DDUtil.
- Power On/Off
- Operate/Stby (toggle)
- PA Temp display
- Antenna selection (toggle: 1-6)
- Output Power (toggle: Low/Med/High)
- Input (toggle: 1-2)
- Tune (initiate)
- Alarms and Warnings display
To connect and use the SPE 2K amplifier follow the steps below.
Connection Data
Two serial connections are required for the SPE 1.3/2K to communicate with DDUtil. One for the remote commands and one for band switching.
